This is a complete parts kit for a Space Charged regenerative radio set.
Space Charge technology is a long proven method of operating high voltage tubes at low voltage.
In fact this set runs cool and safe with only one 9 volt and one 1.5 volt D cell battery
This parts kit can be used in most of the very popular Hiker series of Regenerative Radios.
Here is what's included.
1each New Old Stock #49 vacuum Tube
1 each 5 pin porcelain tube socket
1 each air variable capacitor 381pf
2 each 100pf mica capacitors
1 each 2 Meg 1/2 watt resistor
1 each 500k pot with switch
1 each 1.25" diameter coil form
1 each 60' spool of #30 magnet wire.
2 each coil form mounting brackets
1 each 9 volt battery holder
1 each 1.5 volt D cell battery holder
1 each schematic diagram with parts layout and wiring diagram
1 each capacitor mounting bracket with mounting screws.
1 each Potentiometer mounting bracket
1 each hank of #24 hookup wire.
7 each Fahnestock clips
1 each #6 solder lug with mounting screw. For connection to back of capacitor.
7 each # 6 solder lugs to mount on fahnestock clips.
Note this is a parts kit only with no step by step instructions, use parts layout and wiring diagram for assembly instructions.
Magnetic head phones needed best if under 1000 ohms or
Use a bogen T725 audio transformer to match most magnetic headphones.
All of the parts that are included in this kit are show in the photo .
Schematic diagram below is simplified and does not show the power switch.
